Shop-Vac ESL Serie Manuel D'utilisation page 9

TIGHTEN
FIGURE 23
LOOSEN
FIGURE 24
FIGURE 25
FIGURE 26, 27
INSTALLING THE DISPOSABLE FILTER BAG:
(Not standard with all models)
38. Use for dry pick up only. Use in conjunction with
cartridge filter for picking up soot, cement, plaster or
drywall dust.
39. With cord disconnected from receptacle, pull latches
in an outward motion and remove tank cover.
FIGURE 28
PAGE 8
36. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise
to loosen and remove, slide
the cartridge filter off the lid
cage. FIGURE 24, 25.
37. To clean the cartridge
filter shake or brush off
excess dirt or rinse (from
the inside of the filter)
with water, dry completely
(approximately 24 hours)
and re-install. FIGURE 26,
27. Note: If the filter has
been used for wet pick up,
it must be cleaned and dried
before using for dry pick up.
40. Unscrew hose locking-nut
and remove hose from inlet.
FIGURE 28.
INSTRUCTIONS FOR UP AND DOWN
DEFLECTOR:
FIGURE 29
FIGURE 30
FIGURE 31
44. When secured in place, expand bag and position
around the inside of tank.
45. Use for dry pickup only.
INSTRUCTIONS FOR SIDE TO SIDE
DEFLECTOR:
1
FIGURE 32
NOTE: Hose must be
removed before inlet deflector
can be taken out.
41. Remove deflector from
retainer guide. FIGURE 29.
42. Make sure curve of the
deflector is in a downward
position, slide collector bag
collar over deflector matching
notches of collar to tabs on
deflector. FIGURE 30.
43. Slide deflector with
collector bag attached into
retainer guide.
FIGURE 31.
NOTE: Hose must be
removed before inlet deflector
can be taken out.
46. Remove inlet deflector
from deflector guide.
FIGURE 32.