GYS STARTPACK 12.24 CI Mode D'emploi page 16

Translation of the original instructions
BATTERY REPLACEMENT
STARTPACK 12.24 CI
4
Product
STARTPACK 12.24
Regardless of how the STARTPACK 12.24 is being used (12V or 24V), always replace both batteries at
the same time.
1
To replace the batteries:
• Disconnect the booster from the mains beforehand.
• Unscrew the back shell ( 1 - 7 screws) and remove it.
• Once the back panel has been removed, the batteries are visible, with one in front of the other (see picture).
• To remove them:
- Remove the screws (see illustrations 2 and 3 ) which allow the connection between the batteries and the rest of
the STARTPACK connector system.
- Then unscrew the fixing bar (striped area
- First remove the front battery.
- And remove the second battery.
Once the first battery is removed, make sure to insulate the terminals to prevent any short cir-
cuit. Then remove the second battery.
When putting new batteries, make sure to match the polarities of both batteries and STARTPACK
12.24 CI. - Terminal on the left, + terminal on the right (see picture).
• Reposition and tighten in this order the bottom battery, the front battery and then the fixing bar. Screw the back
shell back on again to finish.
16
STARTPACK 12.24 CI / PRO 12.24 CI
1
2
Battery Type
G16EP Lead acid battery
) between the two batteries 4 .
Voltage (V) Capacity (Ah)
2 x 12 2 x 16
EN
4
3
Dimensions
Battery ref
(cm)
18 x 8 x 17 53131