Translation of the original instructions
USE IN STARTER MODE
STARTPACK 12.24 CI
Before each start-up, check that the "recharging" indicator is off.
• Disconnect the mains cable.
• Set the switch to OFF.
• Connect the red clamp to the positive terminal (+) and the black clamp to the negative terminal (-) of the battery.
In case of polarity inversion, the STARTPACK will signal it by: buzzer + red LED light on.
• Set the switch to 12 V or 24 V depending on the
vehicle to be started.
• Turn your vehicle key (5 seconds maximum) to activate the starter function.
if your engine does not start, wait 3 minutes between 2 start attempts.
A vehicle that does not start after the third attempt may have a problem other than a faulty battery: e.g. alternator,
glowplug...
Following one or more starts or high battery consumption, the red light flashes to warn you that the internal batteries need to
be recharged. This does not prevent further starting attempts but may damage the battery, causing irreversible damage.
• Once the vehicle has been started, set the
switch to OFF.
• Disconnect the black clamp then the red clamp from the vehicle.
• Set the switch to 12V.
• Connect the appliance to a 230 V 50/60 Hz socket to recharge the internal batteries (see use in charger mode).
USE IN CHARGER MODE (CHARGE INTERNAL BATTERIES)
For the STARTPACK to be always operational and deliver maximum starting power, it is recommended to charge it
after each use and to keep on charge until next used.
The STARTPACK PRO is fitted with an autonomous charger which charges and maintains the internal batteries at
100% and without the need for monitoring (Floating System).
STARTPACK 12.24 CI
• After use, set the switch to OFF and
disconnect the clamps from the vehicle.
• Set the switch to 12V.
• Connect the mains.
If the switch (or connector) is not on 12V, charging does not start and/or an alert message appears.
STARTPACK 12.24 CI / PRO 12.24 CI
STARTPACK PRO 12.24 CI
• Set the battery switch to OFF.
• Connect the switch to 12 V or 24 V depending on
the vehicle to be started.
• Set the battery switch to ON.
• Once the vehicle has been started, set the bat-
tery switch to OFF.
• If the selector switch is set to 24 V, connect it to 12 V.
If it is already on 12 V, leave the selector switch
connected.
STARTPACK PRO 12.24 CI
• After use, set the battery switch to OFF
and disconnect the clamps from the
vehicle.
• Set the voltage connector to 12 V.
12 V
EN
13