How To Use - CombiSteel FCU-1200 Mode D'emploi

Before use
 Remove shipping package, tape, etc. Also leave the doors open for ventilation.
 Clean the interior compartment.
 Plug the appliance into the mains socket and allow the appliance to operate for about 1 hour to cool the
compartment before placing items in the appliance.
Wait for at least 5 minutes before re-starting
Restarting the appliance immediately after it has been turned off may cause fuses to blow and activate the
circuit-breaker, thus, the compressor may be overloaded, and/or damage may occur.
You can turn the thermostat to adjust the interior temperature. Turn the thermostat right for temperature inside
the appliance to go down. To raise the interior temperature, turn the thermostat left.
Drain tray
Defrosting is performed automatically and drain water is collected in the drain tray.
Water in the drain tray is evaporated automatically. It is recommended that you clean out your drain tray at least
once a day.
Efficient use
To prevent cold air from escaping, open and close the door(s) quickly and keep the door(s) opened for as short
a time as possible. Please install the appliance in the place which is well-ventilated.
Shelf height adjustment
The shelf height can be adjusted.
Arrange the shelves in accordance with the dimension of the items to be placed inside the appliance.
Placing items in the appliance
This appliance employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items
will not be adequately refrigerated. Pay attention to the following points:
 Do not allow items to obstruct the air inlet and outlet.
 Place items so that they do not protrude from the shelves. The gap between the shelves and the door is used
for circulation of cold air.
 Place items evenly on all shelves.
 Please do not display goods on the bottom. Please put goods on the shelf.

HOW TO USE

7