Operation; Removing The Bodywork; Inserting The Aerial Tubes; Inserting Batteries/Rechargeable Batteries In The Transmitter - Reely « Eraser » Brushless 4WD RtR Notice D'emploi

9. Operation

a) Removing the bodywork
Remove the four safety clips on the upper side of the vehicle and lift the body off upwards.
b) Inserting the aerial tubes
Route the aerial cables through the aerial tube included.
Plug the aerial tube into the corresponding bracket on
the vehicle (see arrow in the image on the right). Let any
excess aerial cable protrude slightly from the end of the
aerial tube.
Important!
Never cut the aerial cable! Never coil the aerial
cable! This significantly reduces the transmis-
sion range.
c) Inserting batteries/rechargeable batteries in the transmitter
Open the battery compartment on the transmitter and insert either batteries or fully charged rechargeable batteries.
Please observe the correct polarity (pay attention to plus/+ and minus/-), see labelling in the battery compartment.
Replace the battery compartment cover.
Follow the operating instructions included for the remote control system.
d) Putting the transmitter into operation
Switch on the transmitter and set the trim for the steering and driving functions in the central position.
If the transmitter has a dual rate function, deactivate it or adjust it so that the steering lock is not limited.
Follow the operating instructions included for the remote control system.
41