Beninca CP.JT Mode D'emploi page 18

Some messages that are displayed in the event of malfunctions are shown hereunder:
Error, radiotransmitter self-adjustment
or
err
self-learning
Error, motor
Err1
Error, photocells
Err2
Error, encoder
Err3
Triggering of the amperometric sensor
amp
Triggering of the thermal switch
THRM
In the event of malfunctions (limit switches, control and safety) can be displayed. One segment of the display is linked to each input. In
the event of failure it switches on according to the following scheme.
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal segments.
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal and
the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a specialised
company.
18
ERROR MESAGES
If the error occurs during self-learning, check the STOP/PHOT/BAR/PP/OPEN/
CLOSE inputs or whether frictions occur during the door leaf stoke.
If the error occurs during self-learning of the radio-transmitters, this means that
the memory of the receiver is no longer able to receive other transmitters or the
transmitter is not compatible.
Check connections to the motor
Check connections to photocells
Check connections to the encoder
An obstacle or a point of friction has caused the triggering of the amperometric
sensor. Remove the obstacle or check the door stroke. Act on the PMO/PMC/
PSO/PSC parameter, if required.
The control unit has switched the system to a rest status due to an excessive
number of consecutive operations. If a sufficient cooling time has elapsed, the
control unit is reset to normal operation.
In the negative, a fault in the motor might have occurred, which requires the
replacing of the motor.
DIAGNOSTICS
P.P. OPEN CLOSE
PHOT STOP DAS
WASTE DISPOSAL