Costan BLUES 4 Mode D'emploi Pour L'utilisateur page 15

PUTTING INTO OPERATION
Check that the voltage on the identifcation plate is the same as that of the
network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERA -
TOR WILL HA VE TO BE CONNECTED IS TO BE PROTECTED BY
AVERY SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA);
IT ISALSO TO BE LINKED TO THE GENERALEARTHING PLANT.
The manufacturer disclaims all responsability for any damage to people or
things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law. Absolutely never use re -
duction units, patch cords, adapters or multiple socket outlets to connect
the counter. DIRECTLY connect the equipment to the mains.
PERIODICAL MAINTENANCE
Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is da-
maged, don't use the equipment and don't try to repair it: to prevent any risk, it must be replaced by
the manufacturer, by a member of the after-sales service staff, or anyway by a person having similar
qualifcations. In any case, none of the protective elements (the grill, the carter) must be removed by
non qualifed staff. Absolutely avoid using the refrigerator without such protection.
The replacement of neon tubes must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNALBODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEELSURFACES : wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the fnish of the stainless steel.
SURFACES IN PLASTIC MATERIAL : wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: only use products specifcally designed for glass cleaning ; It is not advisable
to use ordinary water which can leave a flm of calcium on the surface of the glass.
TANK WASHING
Proceed as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature.
2) Switch off the unit by pushing on main switch (if present) and unplug the unit directly.
3) Leave the glass door open and begin the operation of tankwashing when the tank temperature is
equal to the ambient temperature.
4) Wash and dry the tank using neutral soap and soft cloth.
Plug in again and wait till the appliance reaches the right temperature before flling it again.
Do not use jet of water to clean the cabinet: electrical wiring can have damages.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
All manuals and user guides at all-guides.com
Periodically remove from the fnned condenser unit the impurity
(dust and deposit) which remain among the fns of the condenser,
obstructing a good circulation of the air .A dirty condenser reduces
the performance of the equipment, increasing the energy consumption.
Cleaning should be carried out with a soft brush or preferably with
a vacuum cleaner. The manufacturer recommends that this ope-
ration be carried out only by an Authorized Technician.