What To Do If; General Conformity Declaration - Becker Centronic SunWind Control SWC441 Mode D'emploi

Operating Instructions
Problem
Drive is not functioning,
transmission control
light is not lit.
Drive is not
functioning;
transmission control
light is illuminated.
Transmission control
light is flashing.
Automatic control
commands are not
executed.
The system is not
extended automatically
when the sliding switch
is set to " "
The system does not
extended manually
when the sliding switch
is set to " " or " "
Becker hereby declares that the Centronic SunWindControl SWC 441 complies with
the basic requirements and other relevant regulations of the EC Directive 1999/5/
EG.
For use in the following countries: DE, BE, FR, NL, AT, LU, IT, GB, ES, CH, CZ, DK, FI,
HU, NO, PT, SE, IE, GR, PL
Subject to technical changes without notice.

What to do if ...?

1. Batteries are dead.
2. Batteries are incorrectly
inserted.
1. Receiver outside the radio
range.
2. Transmitter is not
programmed in the receiver.
Batteries are running out.
Sliding switch not in the
" " position.
1. Sunlight intensity is
below the threshold value.
2. Wind speed exceeds
threshold value
Wind speed exceeds
threshold value

General conformity declaration

Cause
19
Remedy
1. Insert new batteries.
2. Insert batteries correctly.
1. Reduce distance to the
receiver.
2. Programme transmitter.
Insert new batteries.
Set sliding switch to the
position
1. Adjust sun threshold value
2. Wait until wind abates
Wait until wind abates
" "