What To Do If - Becker Centronic SunWindControl SWC545-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Problem
Drive is not function-
ing.
The transmitter does
not react after the
batteries have been
changed.
The word BATTERY is
displayed.
The required drive is
not functioning.
Curtain/fabric does
not move into the end
position.
Automatic control
commands are not
executed.
The system is not
extended automatically
when the sliding switch
is set to "".
50
What to do if ...?
Cause
1. Batteries are dead.
2. Batteries are incor-
rectly inserted.
3. Receiver outside the
radio range.
4. Transmitter is not
programmed in the
receiver.
Power supply has been
interrupted for too long.
Battery power is low.
Incorrect channel
selected.
End position is not set.
1. Sliding switch not in the
"" position.
2. Winter setting is set to
ON.
3. The automatic sun
protection function
was interrupted by a
manual command.
1. Sunlight intensity is
below the threshold
value.
2. Wind speed exceeds
threshold value.
Remedy
1. Insert new batteries.
2. Insert batteries cor-
rectly.
3. Reduce distance to
the receiver.
4. Programme transmit-
ter.
Press the RESET button.
Check settings.
Replace batteries.
Correct channel se-
lected
Set end position in
setting menu SUN END
POSITION or TIME END
POSITION.
1. Set sliding switch to the
"" position.
2. Set winter setting to
OFF.
3. Turn the sliding switch
from "" to "" and
back to "".
1. Adjust sun threshold
value.
2. Wait until wind abates.