Technical Data; What To Do If - Becker Centronic MemoControl MC511 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Nominal voltage
Type of battery
Protection class
Permissible surrounding temperature
Radio frequency
Problem
Drive is not functioning,
transmission control
light is not lit.
Drive is not functio-ning,
transmission control
light is lit.
Transmission control
light is flashing.
Drive does operate in a
24 hour cycle.
Switching times differ
from those programmed
18
Technical data
What to do if ...?
Cause
1. Battery is dis-
charged.
2. Battery is incorrectly
inserted.
1. Receiver outside the
radio range.
2. Transmitter is not
programmed in the
receiver.
Battery is running out.
1. Sliding switch not in
the manual position
2. Operating time not
programmed
Power failure affecting
the tubular drive
3 V DC
CR2032
IP 20
-10 to +55 °C
868.3 MHz
Remedy
1. Insert new battery.
2. Insert battery cor-
rectly.
1. Reduce distance to
the receiver.
2. Programme transmit-
ter.
Insert new batterie.
1. Set sliding switch to
the clock position
2. Programme operat-
ing time
Reprogramme the
switching times