MBM CPG77T Manuel D'installation Et D'utilisation page 32

The appliance must only be used
for the purposes indicated. Any
other use must be considered
"IMPROPER" and therefore the manu-
facturer declines all liability for any con-
sequent damage to persons or property.
Do not obstruct the heat extrac-
tion and/or dissipation openings.
Do not leave flammable objects
or material near the appliance.
stream the appliance whenever you
need to work in safe conditions.
Whenever it is necessary to oper-
ate inside the appliance (connec-
tions, commissioning, checking
operations, etc.) prepare for the neces-
sary operations (removal of panels,
elimination of supply) in compliance with
the safety conditions.
DUTIES AND QUALIFICATIONS
REQUIRED OF OPERATORS
Prohibition for the homogeneous
operator to perform any type of
operation (maintenance and/or
other) without having first read the entire
documentation.
The information contained
in this document is for the
use of the qualified techni-
cal operator who is authorised for: han-
dling, installation and maintenance of
the appliance in question.
The operating instructions
have been drawn up for
the "Generic" operator
(Operator with limited responsibilities
and tasks). Person authorised and em-
ployed to operate the appliance with
guards active and capable of perfor-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Disconnect all sup-
plies (e.g. water -
gas - electrical) up-
ming routine maintenance (cleaning the
appliance).
The operators who use the appli-
ance must be trained in all as-
pects concerning its functioning
and safety features. They must there-
fore interact using appropriate methods
and instruments, complying with re-
quired safety standards.
The "Generic" operator must op-
erate on the appliance after the
technician has completed instal-
lation (transportation, fixing electrical,
water, gas and drain connections).
WORK AREAS
AND HAZARDOUS ZONES /
To better define the scope of interven-
tion and the relevant work zones, the
following classification is provided:
• Dangerous zone: any zone within
and/or in proximity to a machine in whi-
ch the presence of an exposed person
constitutes a risk in terms of the health
and safety of such a person;
• Exposed person: any person that is
found wholly or partly in a dangerous
zone.
Maintain a minimum distance
from the appliance when operat-
ing in such a way as to avoid en-
dangering the safety of the operator in
case of unexpected circumstances
The following are also danger zones /
• All the work areas within the appliance
• All the areas protected by appropriate
safety and protection systems such as
safety photocell photoelectric curtains,
protective panels, interlocked doors,
protective casing.
• All the zones within the control units,
electrical cabinets and junction boxes.
• All the zones around the appliance in
operation when the minimum safety dis-
tances are not being respected.
EQUIPMENT REQUIRED
FOR INSTALLATION /
- 6 -
.