Skil 2148 Notice Originale page 7

! only use bits with hexagon shaft
• When turning in a screw at/near the
cross cut end or an edge of wood,
pre-drill a hole in order to avoid
cracking of the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one
should pre-drill a hole
• For more tips see
www.skileurope.com
• Vibration level
The vibration emission level stated at
the back of this instruction manual has
been measured in accordance with a
standardised test given in EN 60745; it
may be used to compare one tool with
another and as a preliminary
assessment of exposure to vibration
when using the tool for the
applications mentioned
- using the tool for different
applications, or with different or
poorly maintainted accessories, may
signifi cantly increase the exposure
level
- the times when the tool is switched
off or when it is running but not
actually doing the job, may
signifi cantly reduce the exposure
level
! protect yourself against the
effects of vibration by maintaining
the tool and its accessories,
keeping your hands warm, and
organizing your work patterns
MAINTENANCE / SERVICE
• Keep tool and charger clean
- clean charging contacts in charger
with alcohol or contact cleaner
! unplug charger from power
source before cleaning
• If the tool/charger should fail despite
the care taken in manufacturing and
testing procedures, repair should be
carried out by an after-sales service
centre for SKIL power tools
- send the tool or charger
undismantled together with proof of
purchase to your dealer or the
nearest SKIL service station
(addresses as well as the service
diagram of the tool are listed on
www.skileurope.com)
ENVIRONMENT
• Do not dispose of electric tools,
batteries, accessories and
packaging together with household
waste material (only for EU countries)
- in observance of European Directive
2002/96/EC on waste of electric and
electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned to
an environmentally compatible
recycling facility
- symbol @ will remind you of this
when the need for disposing occurs
! remove the batteries before
disposal of the tool #
F
Tournevis sans fil
INTRODUCTION
• Cet outil avec rotation à droite/gauche
est conçu pour le vissage au bois
• Lisez et conservez ce manuel
d'instructions 3
SPECIFICATIONS TECHNIQUES 1
Couple max. vissage dur suivant
ISO 5393: 7 Nm
ELEMENTS DE L'OUTIL 2
A Interrupteur pour mise en marche/arrêt
B Commutateur pour inverser le sens de
rotation
C Porte-embout
7
2148