Sentiotec VitaMy 164 Serie Instructions De Montage Et Mode D'emploi page 71

Instructions for installation and use
Installation of the bench cushion and the IR thermal plate
Fig. 32: Installation of the bench cushion
Screw in the bench cushion left and right in the cabin as well as the bench cushion
bar on the electric element with 2 screws each.
Fig. 33: Installation of the U-strips for the thermal plates
Screw in the U-strips for thermal plates left and right in the cabin with 2 screws
each. Make sure that the switch is located at the top.
p. 27/44
Screws
6 units: 5 x 70
Screws
4 units: 3.5 x 50
EN