Sentiotec VitaMy 164 Serie Instructions De Montage Et Mode D'emploi page 62

Instructions for installation and use
Fig. 14: Attaching the skirting
Attach skirting by squeezing the side wall elements until the anchors are no
longer visible.
Roof element installation
Check the right angle alignment of the cabin in the corners or use the measuring
tape to measure the two diagonals of the cabin; if these are the same length,
the cabin is properly aligned.
Fig. 15: Roof support slats installation
Screw the roof support slats on all the walls of the cabin firmly, as shown in Fig-
ures Abb. 14 and Abb. 15. Be sure that the wall elements and the roof support
slat are flush.
WARNING!
Be sure that each support slat is correctly attached and that all of the
screws have been used.
p. 18/44
Screws
14 units: 3.5 x 50