Sentiotec VitaMy 164 Serie Instructions De Montage Et Mode D'emploi page 75

Instructions for installation and use
Connecting the LED strips
Fig. 39: Connecting the LED strips with the control
Run the power supply of the LED lighting under the bench. Run the connecting
cable and the power cable through the opening in the rear wall towards the outside.
When connecting the LED strip, pay attention to the arrow on the plug.
This has to be on the side of the strip with the label "+ 12V". The mains
plug of the LED lighting has to be located outside of the cabin.
Fig. 40: Inserting the bench
Place the bench on the support slats.
p. 31/44
EN