Lubricate The Front Casters; Cutting Height Adjustment; Operator Platform Suspension Adjustment - Snapper PRO SS100 Serie Manuel D'utilisation

Lubricate the Front Casters

Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 28) screwed into the
caster and install a 1/4-28 grease fitting.
28
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the 1/4-28
bolt.
4. Repeat the process for the other side of the machine.

Cutting Height Adjustment

The cutting height is adjustable between 1-3/4" (4,5
cm) and 4-1/2" (11,4 cm) in 1/4" (0,64 cm) increments.
Figure 29 depicts the cut height plate and the cut height
decal for the unit. This figure is intended to help you better
understand the available cutting heights for this unit.
29
To set the cutting height at 1-3/4" (4,5 cm):
1. Pull the deck lift lever (A, Figure 30) back towards the
operator position until it locks into the 4-1/2" (11,4 cm)
TRANSPORT position.
24
30
2. Remove the cutting height adjustment pin (B) from the
hole that it is installed in and put it in the storage location
hole (A, Figure 29).
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button (C, Figure 30) to
release the transport position lock.
4. Push the deck lift lever forward until it contacts the
stationary pin in the 1-3/4" (4,5 cm) hole.
To set the cutting height in the range of 2" (5,08 cm) and
4-1/4" (10,8 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 4-1/2" (11,4 cm) TRANSPORT
position.
2. Place the cutting height adjustment pin in the desired
cutting height hole.
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button to release the
transport position lock.
4. Push the deck lift lever forward until it contacts the cutting
height adjustment pin.
To set the cutting height at 4-1/2" (11,4 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 4-1/2" (11,4 cm) TRANSPORT
position.
2. Place the cutting height adjustment pin in any open hole.
The deck lift lock latch (D) holds the mower deck at the
4-1/2" (11,4 cm) position while cutting.
Note: Make sure that the cutting height adjustment pin is
inserted into the holes in both upper and lower plates of the
pin box (E).
Operator Platform Suspension
Adjustment
The lower mounting position of the shock assembly linkage
(A, Figure 31) that connects to the operator platform (B)
snapperpro.com