Operation Adjustments - HOLZMANN MASCHINEN UBM 760 Mode D'emploi

OPERATION
12.3

Operation adjustments

Basically the machine is supplied ready for use. To optimize
the function of machine maybe some adjustments has to
be done.
To make the use easy and precise adjust screw (2) so that
the exerted needed force is adequate.
In the cutting operation of the machine the sheet will be
clamped between the table and the downholder. The
downholder can be set with the adjustment (1) to the
required sheet thickness on both sides of the machine
To set the cutting table loosen the screw and adjust the
table to a position so that the blade has a free run. After
the setting retighten the screw
For bending the different segments can be removed or
replaced, depending on workpiece size, so that a defined
bending edge can be generated. For this purpose, loosen
the screw of the corresponding segment to move or
remove this. After new setting retighten the screw.
For rolling function the rear and upper roller can be adjusted. To
adjust the distance and thus the roll diameter use the set screw at
the rear side of the machine. If this role is not adjusted in parallel,
for example, conical shell are produced.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 14
UBM 760 / UBM 760MS