Electric Ignition Surface Burner; Adjust The Low Setting Of Surface Burner Valves; Operation Of Oven Burners And Oven Adjustment - Frigidaire Gallery FGGF304DPF Instructions D'installation

30" GAS RANGE INSTALLATION INSTRUCTIONS
7

Electric Ignition Surface Burner

Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power. To check for proper lighting:
A. Push in and turn a surface burner knob to the LITE
position. You will hear the igniter sparking.
B. The surface should light when gas is available to
the top burner. Each burner should light within four
(4) seconds after air has been purged from supply
lines. Visually check that burner has lit.
C. Once the burner lights, the control knob should be
rotated out of the LITE position.
D. There are separate ignition devices for each burner.
Try each knob separately until all burner valves
have been checked.
8
Adjust the "LOW" Setting of Surface
Burner Valves
A. Push in and turn each control to LITE until burner ignites.
B. Push in and quickly turn knob to LOWEST POSITION.
C. If burner goes out, Reset control to OFF.
D. Remove the surface burner control knob.
E. Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased with the turn of the
screw.
NOTE: On models with twin burners (two rings of fl ame),
only the outer burner is adjustable.
Burner Flame Size
Adjust fl ame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing the fl ame. Flame
should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface
burners.
9
Operation of Oven Burners and Oven
Adjustments
Electric Ignition Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power.
The oven burner is equipped with an electric control
system as well as electric oven and broil burner igniters.
These control systems require no adjustment. When the
oven is set to operate, current will fl ow to the igniter. It will
"glow" similar to a light bulb. When the igniter has reached
a temperature suffi cient to ignite gas, the electrically
controlled oven valve will open and fl ame will appear at the
oven burner. There is a time lapse from 30 to 60 seconds
after thermostat is turned ON before the fl ame appears
at the oven burner. When the oven reaches the display
setting, the glowing igniter will go off. The burner fl ame
will go "out" in 20 to 30 seconds after igniter goes "OFF".
To maintain any given oven temperature, this cycle will
continue as long as the display is set to operate.
After removing all packing materials and literature from
the oven:
A. Set the lower oven to BAKE at 300°F. See Use &
Care Guide for operating instructions.
B. Within 60 seconds the oven burner should ignite.
Check for proper fl ame, and allow the burners to
cycle once. Reset controls to OFF.
C. Repeat A and B with the upper oven.
D. Set the upper oven to broil. See Use and Care Guide
for operating instructions.
E. Within 60 seconds the broil burner should ignite.
Check for proper fl ame. Reset controls to off.
9
Main
Top