Electrical Requirements; Assembly Of The Burner Caps - Frigidaire Gallery FGGF304DPF Instructions D'installation

30" GAS RANGE INSTALLATION INSTRUCTIONS
5

Electrical Requirements

120 volt, 60 Hertz, properly grounded dedicated circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension cord with this range.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be
properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 6) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by
a qualifi ed electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wall receptacle is installed,
it is the personal responsibility and obligation of the
Preferred Method
Grounding type
wall receptacle
Figure 6
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Do not, under any
circumstances,
cut, remove,
or bypass the
grounding prong.
Power supply
cord with 3-prong
grounding plug.
6

Assembly of the Burner Caps

Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may
be hot enough to cause burns.
Install Burner Caps
This cooktop is equipped with sealed burners. All pieces
are at their place. Take note where they are. Remove all
packaging material. Make sure the burner caps are
properly aligned and leveled. The burner cap lip (See
Figure 7) should fi t snug into the center of burner head
and rest level. Refer to Figures 8 & 9 for correct and
incorrect burner cap placement. Once in place, you may
check the fi t by gently sliding the burner cap from side
to side (Figure 10) to be sure it is centered and fi rmly
seated. When the burner cap lip makes contact inside
the center of the burner head you will be able to feel
it. Please note that the burner cap should NOT move
off the center of the burner head when sliding from
side to side. NOTE: There are no burner adjustments
necessary on this cooktop.
Burner Cap
Burner
Head
Correct Burner
Cap Placement -
Fig. 8
Fig. 10
8
Burner Cap Lip
Fig. 7
Incorrect Burner
Cap Placement -
Fig. 9