Multiplex EasyStar 1 3200 Notice De Construction page 20

1. Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely
hope that you are (very) happy with the contents of your kit. However, we would ask you to check all the parts
before you start construction, as we cannot exchange components which you have already worked on. If you
find any part is not acceptable for any reason, we will readily correct or exchange it. Just send the component to
our Model Department. Please be sure to include a brief description of the fault.
We are constantly working on improving our models, and for this reason we must reserve the right to change the
kit contents in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification.
Please understand that we cannot entertain claims against us if the kit contents do not agree in every respect with
the instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating
them safely requires a certain level of technical competence and manual skill, together with discipline and
a responsible attitude at the flying field. Errors and carelessness in building and flying the model can
result in serious personal injury and damage to property. Since we, as manufacturers, have no control
over the construction, maintenance and operation of our products, we are obliged to take this opportunity
to point out these hazards and to emphasise your personal responsibility.
Additional items required: 8 AA-size dry or rechargeable cells for the transmitter power supply
Second flight pack for even more fun:
MULTIPLEX NiCd flight pack
Tools:
Allen key, 1.5 mm A/F, included in accessory pack.
Specification:
Wingspan
Overall length
Fuselage length
All-up weight
Wing area
Wing loading
RC functions
Important note - repairs:
This model is not made of styrofoam™, and it is not possible to glue the material using white glue or
epoxy. Please be sure to use cyano-acrylate glue exclusively, preferably in conjunction with cyano activator
(kicker). We recommend medium-viscosity cyano. This is the procedure: spray cyano activator on one
face of the Elapor®; allow it to air-dry, then apply cyano adhesive to the other face. Join the parts,
immediately position them accurately, and wait a few seconds for the glue to cure.
Please take care when handling cyano-acrylate adhesives. These materials harden in seconds, so don't
get them on your fingers or other parts of the body. We strongly recommend the use of goggles to protect
your eyes. Keep the adhesive out of the reach of children.
1. Before final assembly
Check the contents of your kit.
You will find the parts list helpful here.
2. Final assembly
The tailplane and fin are attached to the fuselage using the double-sided tape provided. However, you must first
run the wire pushrods through the pushrod connectors fitted to the rudder and elevator horns. Peel the backing
paper from the tape and place the tailplane on the model, taking care to position it at right-angles to the fuselage.
Don't press the parts together firmly initially. Check alignment carefully, then press down firmly. Repeat the procedure
with the fin.
20
400 motor / 6 x AA cells approx.
Aileron, elevator and motor
GB
6 / 500 mAh
1370 mm
917 mm
870 mm
680 g
approx. 24 dm²
approx. 28 g/ dm²
# 1 3200 to 1 3203
Order No. 15 5545