Meec tools 012683 Mode D'emploi page 69

The auger does not
stop when the auger
lever is released.
The snowblower does
not throw snow.
Auger lever wire incorrectly adjusted.
Ejector chute blocked.
One or more shear pins have sheared off.
Foreign object blocking the auger.
Auger lever wire adjusted incorrectly.
Rotor drive belt loose or damaged.
Adjust the auger lever wire.
Switch off the engine immediately,
remove the ignition key, and wait until
all moving parts have stopped. Clear
the ejector chute with the clearing tool
or a stick.
Replace the shear pins.
Switch off the engine immediately and
remove the ignition key. Remove the
foreign object from the auger.
Adjust the auger lever wire.
Replace the belt.
EN
69