Publicité
Les langues disponibles
Les langues disponibles
EN
ELECTRIC START
1.
Plug the plug into a 230 V earthed power
point.
2.
Put the ignition knob in ignition mode.
3.
Set the throttle lever in the high revs
position.
4.
Close the choke if the engine is cold.
5.
If the engine is cold, block the ventilation
hole and press the primer bulb 3–5
times. If the engine is warm, block the
ventilation hole and press the primer bulb
once.
6.
Press the start button. Release when the
engine has started. The starter motor has
an overload protection that trips if the
engine overheats. The starter motor must
cool before attempting to start again.
7.
Slowly move the choke lever to the open
position when the engine warms up. If
the engine stops, start it again and let it
run for a while with the choke half-open
before slowly moving the choke lever to
the open position (no choke).
8.
Unplug the plug from the power point
first, and then from the snowblower.
DRIVE LEVER
The drive lever is placed on the right handle.
Press the drive lever towards the handle
to engage the wheel drive, then release to
disengage.
GEAR LEVER
It gear selector has 8 positions for driving
forwards and reversing at different speeds.
FIG. 7
IMPORTANT:
Always disengage, i.e. release the gear lever
before changing gear.
62
Forward
The machine has 6 forward gears (F), where 1
is the slowest. Drive at the lowest speed when
snow throwing.
Back
The machine has 2 reverse gears (R), where R1
is the slowest.
Function check
Check the functionality of the drive lever and
gear lever in accordance with the instructions
below.
1.
Switch off the engine and put the gear
lever in the position for the highest
forward gear. Release the drive lever
and push the machine forwards. The
snowblower should roll forwards. Press
the drive lever. The wheels should stop
turning.
2.
Release the drive lever and push the
snowblower forwards again.
3.
Move the gear lever to the position for
the highest reverse gear and back to the
position for the highest forward gear.
The gear lever should move easily and the
wheels should start turning.
4.
If the gear lever is stiff, of if the wheels
stop moving, loosen the lock nut on the
drive lever wire and extend the wire one
turn of the nut.
5.
If the wheels do not stop moving when
the drive lever is released, loosen the lock
nut on the drive lever wire and shorten
the wire one turn of the nut.
6.
Repeat this check and readjust, if
necessary. Tighten the lock nut when you
have finished adjusting.
Publicité
