General - Panasonic CQ-VD7001U Manuel D'instructions

General

[VOL]
ASPECT
ASP
P·MODE
17
VOL
MUTE MUTE
[MUTE] [MODE] (POWER)
Preparation: Turn your car's ignition key to the ACC or ON position.
General Operations
Operations
Power
[MODE]
–
ON :
[PWR]
[MODE]
Power
–
OFF :
[PWR]
¡Press and hold for more than 2 seconds.
Display Open/Close
–
Note:
¡When the display unit is opened or closed, a loud beep sounds three times.
¡If the unit stops halfway, press [O/C] (OPEN/CLOSE) again to draw it all the way in.
¡Opening/closing the display can be done when the power is off.
Mode selection
(a page 17) [MODE]
...... Touch/Press and hold for more than 2 seconds
18
CQ-VD7001U
[O/C] (OPEN/CLOSE)
[TILT]
OPEN / CLOSE
TILT TILT O / C O / C
CQ-VD7001U
DISC
TUNE / ENTER ENTER
POWER NAVIGATION EJECT
TRACK
MODE MODE MENU NAVI
[] ] [[ ]
Remote Control Sensor
[MODE]
or
END
DVD VTR
RADIO CH-C
[MODE]
or
[O/C]
Press once to open. Press again to close.
–
(OPEN/CLOSE)
[MODE]
RADIO (AM/FM)
DVD (DVD/VCD (Video CD)/CD/MP3/WMA)
VTR
CH-C (CD Changer Control)*
1
or
CH-C (DVD Changer Control)* 1
or
XM (XM Satellite Radio Control)* 1
or
AUX* 2
* 1 CD Changer, DVD Changer and XM Satellite Radio cannot be con-
nected at once.
* 2 AUX appears when there is no connection to the DIN connector.
[PWR] [MODE]
(POWER)
POWER
PWR PWR MODE MODE MENU
STOP PAUSE PLAY
TRACK / SEARCH
DVD MENU RETURN
DVD RET
TITLE/CHAPTER RANDOM
TITLE RAND SCAN
ST/ MONO SUBTITLE
AUDIO ANGLE SUB
1 2 3
4 5 6
7 8 9
ASPECT SCROLL
A 0 SCRL
P-MODE
CAR AV
General Operations (continued)
Operations
Volume
Note:
¡The sound level for
each source is
stored in memory.
Mute
Tilt Angle
(a page 28)
(a page 22)
(a page 30)
(a page 32) Folding Down the
Display
Temporarily
(a page 33)
(a page 36)
(a page 31)
NAVIGATION
NAVI
DISP
[]] [[]
REP
DISC/FOLDER DISC/FOLDER
[ } ] [ { ]
VOL VOL
MUTE MUTE [MUTE]
q [ } ]
q Up
–
w [ { ] w Down
END
DVD VTR
w q
RADIO CH-C
Setting Range: – 82 dB to 0 dB, default: – 40 dB
Mutes the sound.
[MUTE] [MUTE]
–
To cancel, press again.
q Press and hold for more than 2 seconds.
– [TILT]
–
w Press to adjust. Setup is the same as from
[]] or [[] []] or [[]
–
Warning
¡Do not touch the unit while the display is moving. Inserting hands, fingers or foreign
objects into the unit can cause injuries and damage to the unit.
Note:
¡ Vertical angle (TILT) is saved in the memory, so when the display unit is drawn out
next, it is automatically set at the angle and in the position adjusted before.
¡ After adjusting its angle, also adjust the brightness as well. (
¡ The car model and installation conditions may impose some restrictions on the adjust-
ment of the monitor's angle.
[TILT] To raise the display, press again.
– –
Note:
¡Even when the unit power is off, you can fold down the display te mporarily.
Caution
¡Avoid physical shock to the monitor.
¡Do not place any object on the display unit, or subject it to undue force.
¡Do not move the display forcibly.
¡The monitor movable range may be limited by the type of car, the position where the
display is mounted, etc.
18
MENU. Refer to (display
DISPLAY UNIT
unit) for details. (a page 40)
a page 42)
19
CQ-VD7001U