Basic Configuration Of Camera System; Micro-Sd Card Insertion - Eneo NXD-2012PTZ1080 B Mode D'emploi

CAUTION: Before installing mounting bracket to surface pre-adjust the four mounting
screws "A" on the base of the dome camera to best match the mounting bracket locked
position. Unscrew the locking screw on the side of the dome's base and fit the tab of the
mounting bracket into the locking slot. Screws "A" should not be too tight or too loose
when the dome is in the locked position. After setting the proper positions of screws
"A" remove the mounting bracket and install it to the proper surface. If it is too difficult
to lock the dome in position after the mounting bracket has been installed readjust the
screws "A" by unscrewing them a small amount and try to install dome camera again.
No. Connector
1 3-pin terminal block
2 6-pin terminal block
3 RJ-45
4 STEREO
5 STEREO
The camera must be installed by qualified service personnel in accordance with all local
and federal electrical and building codes.
User can install and change Micro-SD card as shown in the following picture.
1. Open the Micro-SD card cover.
2. Install or change Micro-SD card.
3. Tightly close the Micro-SD card cover to ensure waterproofness.
Basic Configuration of Camera System
Wire Color
RED
WHITE
PINK
GRAY
GREEN
BLUE
BROWN
YELLOW
BLACK
GRAY
BLACK
Description
24VAC or 12VDC+
24VAC or 12VDC-
ALARM INPUT 1
ALARM INPUT 2
ALARM INPUT 3
ALARM INPUT 4
GND
ALARM OUTPUT
Ethernet, RJ-45 port compatible with 10/100Mbps
having PoE functionality
AUDIO OUTPUT
AUDIO INPUT

Micro-SD Card Insertion

EN
25