Connecting The Power; Network Connection & Ip Assignment - Eneo NXD-2012PTZ1080 B Mode D'emploi

Connect power of 12VDC for the camera.
When using a 12VDC adapter, connect the positive (+) pole to the ' + ' position and the
negative (-) pole to the ' - ' position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source
only.
• Be careful not to reverse the polarity when you connect the power cable.
• You can also use the PoE (Power over Ethernet) injector to supply power to the
camera.
• 24VAC is recommended to use for the camera power for stable operation with
heater kit. If using PoE, the heater will not operate at all.
The eneo scanning device tool is used to locate all eneo network cameras in a local net-
work. The tool does not need to be installed with a setup program. The program exe-file
can be started directly from the CD with a simple double click to use the program.
After pushing the button „Find eneo devices" you will get a list of cameras connected to
the local network. Highlight your camera in the list and open a context menu with a click
of the right mouse button.

Connecting the Power

Network Connection & IP assignment
EN
27