Setting Network Dome Camera Protocol; Connections - Eneo NXD-2012PTZ1080 Mode D'emploi

Setting Network Dome Camera Protocol

If a Network Dome Camera is to be installed with a Fastrax keyboard con-
troller, select the default protocol. Consult service personnel if a Network
Dome Camera is installed with device other than a keyboard controller.
Refer to 'Dome Configuration - RS485' section for detailed information.

Connections

Connecting to the RS485
The Network Dome Camera can be controlled remotely by an external
device or control system, such as a control keyboard, using RS485 half-
duplex serial communications signals.
Connecting Alarms
• AI (Alarm Input): You can use external devices to signal the dome ca-
mera to react on events. Mechanical or electrical switches can be wired
to the AI (Alarm Input) and G (Ground) connectors.
• G (Ground): NOTE: All the connectors marked G or GND are common.
• Connect the ground side of the alarm input and/or alarm output to the
G (Ground) connector.
• AO (Alarm Output): The dome camera can activate external devices
such as buzzers or lights. Connect the device to the AO (Alarm Output)
and G (Ground) connectors.
Connecting the Network
The Network Dome Camera supports the operation through the network.
Therefore, it is necessary to connect a standard RJ-45 cable to it. Generally
a cross cable is used for directly connection to PC, while a direct cable is
used for connection to a hub.
Connecting the Power
Connect power of 24VAC or 12VDC 1A for the dome camera.
When using a 12VDC adapter, connect the positive (+) pole to the '+' positi-
on and the negative (-) pole to the '-' position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class
2 power source only.
DE
EN
FR
PL
RU
23