Setting Dome Camera Address (Id); Setting Video Signal, Video Type & Coaxitron Protocol - Eneo IPP-82A0030MIA Guide D'installation Rapide

3 5-pin terminal block
4 4-pin terminal block
5 BNC jack
6 BNC jack
The camera must be installed by qualified service personnel in accordance with all local
and federal electrical and building codes.

Setting Dome Camera Address (ID)

To prevent damage, each dome camera must have a unique address (ID). The factory
default setting is 1.
Refer to Dome Communication section for detailed information.
Setting Video Signal, Video Type & Coaxitron Protocol
You can set video signal with D1 and video type with D2 in S1.
S1-D1 Video Signal
OFF HD-TVI OUTPUT
ON AHD OUTPUT
S1-D2 Video Type
OFF NTSC
ON PAL
You can set coaxitron protocol with D3 and D4 in S1.
10
GRAY
VIOLET
ORANGE
SKY BLUE
BLACK
YELLOW
BLACK & WHITE
SKY BLUE & BLACK
ORANGE & BLACK
BLUE
BLACK
ALARM INPUT 1
ALARM INPUT 2
ALARM INPUT 3
ALARM INPUT 4
GND
ALARM OUTPUT 1
GND
ALARM OUTPUT 2
GND
HD-TVI/AHD OUTPUT
CVBS OUTPUT