Changing The Remote's Battery; Programming A Second Remote - Paradigm PREMIUM WIRELESS Serie Manuel D'utilisation

BASS MODE – BASS+: Increases bass output.
BASS MODE – NORMAL: Restores normal levels.
INPUT: Activates the selected input.

CHANGING THE REMOTE'S BATTERY

Caution! Danger of explosion if battery
is incorrectly replaced. Replace only
with the same or equivalent type.
The remote control for your speaker uses two
AAA type batteries. Access the battery compart-
ment by using a Phillips screwdriver to remove
the screw located on the bottom of the remote.

PROGRAMMING A SECOND REMOTE

This soundbar can be programmed to respond to
a second remote. See "The Menu System" section
of this manual for programming instructions.
Please note: There may be remote controls that
the soundbar cannot learn or that the soundbar
can not learn correctly. Due to the number of
available remote controls, it is impossible to
advise which will or will not work.
Please note: When learning from a second
remote, you will likely find it does not have
buttons that directly correspond with all
available soundbar commands. Not all soundbar
commands have to be programmed. Some remote
controls offer 'function' buttons (F1, F2, etc.)
that can be used to program unique soundbar
commands such as 'NITE.MD' or 'OPTIC'.
Please note: Some remote controls offer discrete
'power on' and 'power off' buttons. Some offer
only a single button to toggle power on and off.
The learning function of the soundbar allows you
to program for either scenario.
Fig. 9
16