Remote Control; Changing The Remote's Battery; Programming A Second Remote - Paradigm Soundscape Manuel De L'utilisateur

REMOTE CONTROL

The Soundscape's Remote (Fig. 14) controls the following:
'POWER ON/OFF': Turns the Soundscape on or off.
'PREVIOUS SOURCE' / 'NEXT SOURCE': Cycles through the
inputs. The order of the inputs is: Digital Optical 1
Optical 2 Digital Coaxial Analog RCA Bluetooth.
'VOL+' / 'VOL–': Adjusts volume level up or down.
'MUTE': Mutes the volume. When muted, the Soundscape will
display 'MUTE'. Pressing this button a second time will restore
the previous volume setting. Additionally, you can turn mute
off by pressing either of the volume buttons.
'MENU': Allows you to enter the Soundscape Menu. Once
the menu is activated, use the 'Scroll Up'
'Scroll Left' / 'Scroll Right'
Press the 'Select' button to accept the various selections.
'SOURCE': Press to cycle through the inputs for playback:
Digital Optical > Digital Coaxial > Analog RCA > Bluetooth.
'ENABLE BLUETOOTH': Press to enable wireless music
streaming from your Bluetooth-enabled mobile phone or
other device. Device must be synced with the Soundscape
prior to listening. For syncing instructions and maximum
range for wireless streaming, see Wireless Bluetooth
Connection instructions, page 13.
'PLAY' / 'PAUSE': Press to play or pause Bluetooth wireless
music playback.
'PREVIOUS TRACK': Press to return to the previous track
during Bluetooth wireless music playback.
'NEXT TRACK': Press to move to the next track during
Bluetooth wireless music playback.
'MUSIC MODE': Press to enable 2-channel music listening
'MOVIE MODE': Press to activate Paradigm Virtual Surround
for a full 5.1 virtual surround sound listening experience.
PROGRAMMING A SECOND REMOTE: The Soundscape
can be programmed to respond to a second remote. See
the 'IR Learning' section of this manual for programming
instructions.
Digital
/ 'Scroll Down'
arrows to access menu features.
Power On/O
Scroll Left/
Prev Source
Select
Source
Enable
Bluetooth
/
Previous Track
Movie Mode*
Fig. 14

CHANGING THE REMOTE'S BATTERY

Your Soundscape's remote control unit
uses two (2) AAA batteries. Access these
batteries by releasing the clip at the
bottom in the rear of the remote control.
Menu
Volume Up/
Scroll Up
Scroll Right/
Next Source
Volume Down/
Scroll Down
Mute
Play/Pause
Next Track
Music Mode*
MODE
* Sonic enhancements
to listening experience
according to mode
CAUTION! Danger of
explosion if battery is
incorrectly replaced.
Replace only with the
same or equivalent battery type.
EN-16