Paradigm PREMIUM WIRELESS Serie Manuel D'utilisation page 3

34. This equipment is a Class II or double
insulated electrical appliance. It has been
designed in such a way that it does not
require a safety connection to electrical earth.
35. Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equiva-
lent type.
36. (The remote control supplied with) This product
contains a AAA battery. If the AAA battery is swal-
lowed, it can cause severe internal burns in just
2 hours and can lead to death.
37. Do not handle leaking or damaged AAA batteries.
38. THIS PRODUCT CONTAINS A AAA BATTERY. IF
MISUSED OR ABUSED THIS CAN RESULT IN:
- Smoke or gas hazard
- Heat hazard
- Fire hazard
- Explosion hazard
WARNING: This product is intended to be operated
ONLY from the AC Voltages listed on the back panel or
included power supply of the product. Operation from
other voltages other than those indicated may cause
irreversible damage to the product and void the product
warranty. The use of AC Plug Adapters is cautioned
because it can allow the product to be plugged into volt-
ages in which the product was not designed to operate.
If the product is equipped with a detachable power cord,
use only the type provided with your product or by your
local distributor and/or retailer. If you are unsure of the
correct operational voltage, please contact your local
distributor and/or retailer.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT: This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Approved under the verification provision of FCC Part 15
as a Class B Digital Device.
Any changes or modifications not expressly approved by
the grantee of this device could void the user's authority
to operate the equipment.
RF EXPOSURE INFORMATION: This equipment
complies with FCC/IC radiation exposure limits set forth
for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines in Supplement
C to OET65 and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels of
RF energy that are deemed to comply without testing of
specific absorption ratio (SAR).
5GHz RF DEVICE STATEMENT: This device operates
in the 5.15–5.25GHz frequency range and is restricted
to indoor use only. Outdoor operations in the 5150–
5250MHz frequency range is prohibited.
CANADA, INDUSTRY CANADA (IC) NOTICES: This Class
B digital apparatus complies with Canadian ICES-003
and RSS-210. Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
RADIO FREQUENCY (RF) EXPOSURE INFORMATION:
This equipment complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines
in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has
very low levels of RF energy that are deemed to comply
without testing of specific absorption ratio (SAR).
2. CAUTION
• Comply with FCC RF exposure compliance
requirement, separation distance of at least 20 cm
must be maintained between this product and all
persons.
• This product and its antenna must not be co-located
or operating in conjunction with any other antenna
or transmitter.
• This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
• Operations in the 5.15 - 5.25 GHz band are restricted
to indoor usage only.
• For operation within 5.15 - 5.25 GHz / 5.25 - 5.35 GHz
/ 5.47 - 5.725 GHz frequency range, it is restricted to
indoor environment.
• This device meets all the other requirements
specified in Part 15E, Section 15.407 of the FCC
Rules.
CONTAINS TRANSMITTER MODULE FCC ID:
2AAWQ-CAPRICA2L
CONTAINS FCC ID: MBBDMRS4
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this product may not cause harmful interference, and
(2) this product must accept any interference received,
including interference that may cause undesired operation.
Paradigm Electronics Inc.
205 Annagem Blvd. Mississauga, ON L5T 2V1
2