SOMFY Soliris io+MY Notice page 9

Soliris io + MY
1] Switch on the power supply.
2] Press the PROG button on the Somfy io control point paired with
the motorised product for about 2 s until the motorised product
completes an up-and-down movement.
3] Briefly press the PROG button on Soliris io + MY.
The motorised product performs another up-and-down
movement.
The Soliris io + MY sensor is paired.
To pair the Soliris io + MY sensor with other io motors or receivers, repeat this procedure.
To pair using an io-homecontrol® control point from a partner brand or a Somfy io bi-directional control
point (e.g. TaHoma), please refer to the relevant guide.
The Soliris io + MY sensor can also be paired with a Somfy io bi-directional control point (e.g. TaHoma),
please refer to the relevant guide.
2.5.2. Checking Soliris io + MY pairing
1] Position the motorised product at the lower end limit.
2] Turn the Wind potentiometer (M) to the Demo position.
The motorised product moves up and down briefly.
3] Turn the anemometer (F) manually to simulate the wind blowing.
The motorised product automatically moves to safety position
after 2 s.
The Soliris io + MY sensor is paired with this io motor or receiver.
Attention
Never leave the Wind potentiometer set to Demo.
2.5.3. Setting the wind sensitivity threshold
Table of thresholds
͉
In addition to the value in km/h and the number of flashes indicating the level set, the corresponding value on
the Beaufort scale is given for information purposes.
Thresholds
km/h
Number of flashes
Beaufort
equivalent
Copyright 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1 2
28 38
★ ★ ★
Bf 5 Bf 6
1]
2]
3]
1]
2]
3]
3 4
49 61
★ ★ ★ ★ ★ ★ ★
Bf 7 Bf 8
ON
PROG.
PROG.
5 6
74 88
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
Bf 9 Bf 10
EN
7