Liability; Specific Safety Advice; Tools Required - SOMFY Soliris io+MY Notice

EN

1.2. LIABILITY

Before installing and using Soliris io + MY, please read these instructions carefully.
The Soliris io + MY sensor must be installed by a home motorisation and automation professional,
in accordance with Somfy's instructions and the applicable regulations in the country of installation.
Any operation of the Soliris io + MY sensor outside the scope of application described above is prohibited.
Such use, and any failure to comply with the instructions given in this guide, absolves Somfy of any liability
and invalidates the warranty.
The installer must inform his customers of the usage and maintenance conditions of the Soliris io + MY
sensor and must provide them with the user and maintenance instructions after installing the Soliris io +
MY sensor. Any after-sales service operation on the Soliris io + MY sensor requires intervention by a home
motorisation and automation professional.
Never begin installing without first checking the compatibility of this product with the associated equipment
and accessories.
Somfy accepts no liability in the event of damage to equipment caused by weather conditions not detected
by the sensor.
Should any doubt arise during installation of the Soliris io + MY sensor or for additional information, consult
a Somfy contact or visit www.somfy.com.

1.3. SPECIFIC SAFETY ADVICE

Attention
To prevent damage to the sensor:
• Avoid impacts!
• Do not drop it!
• Do not submerge it.
• Do not use abrasive products or solvents to clean the product.
• Do not clean it using a water spray or high pressure cleaning methods.
Ensure that the sensor is kept clean and regularly check it is operating correctly.
This sensor does not protect the motorised products in the event of strong gusts of wind. If there is a risk
of this kind of weather, ensure that the motorised products remain closed.
1.4. CONTENTS
Description
A
Soliris io + MY sensor
B Cable (depending on version)
C Screws
D Plugs

1.5. TOOLS REQUIRED

• Drill and drill bit
• Cross-head screwdriver
• Flat-blade screwdriver
• Pencil
• Depending on the sensor version, some accessories required for installation are not supplied with
the kit:
- Power cable whose section is between 0.75 and 1.5 mm
country of installation
2
Quantity
1
1
2
2
and meeting the standards in force in the
2
Copyright 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Soliris io + MY
A
C
D
B