SOMFY Soliris io+MY Notice page 12

EN
3] Unscrew the front panel of the mounting bracket (O) to remove
the housing and access the terminal blocks and the mode selector.
4] If necessary, loosen the screws fastening the mounting bracket
to the wall.
2.6.3. Unpairing Soliris io + MY from an io receiver or motor
The procedure to be followed to unpair Soliris io + MY from an io receiver or motor is identical to the pairing
procedure, see 2.5.1.
2.6.4. Replacing a broken or faulty Soliris io + MY
1] Press the PROG button on the Somfy io local control point until
the motorised product performs an up-and-down movement (≈
2 s).
2] Press the PROG button (I) on the new Soliris io + MY sensor for
7 seconds :
The Wind LED (K) on the new Soliris io + MY sensor is lit green
after 2 seconds and remains lit for 5 seconds:
All the broken or faulty sensors are deleted from the memory of the io motor(s) or receiver(s).
3] Pair the new Soliris io + MY sensor with the io motor(s) or receiver(s); see 2.5.1.
2.6.5. Returning Soliris io + MY to its original configuration
1] Press the PROG button (I) on Soliris io + MY for 7 seconds :
The Wind LED (K) is lit green after 2 s and remains lit for 7 s :
The original Soliris io + MY settings have been restored and the io bi-directional control points have been
deleted.
2] To use Soliris io + MY again, carry out a complete commissioning procedure; see 2.5.
10 Copyright 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
3]
K
1]
PROG.
2 s
2]
7 s
PROG.
Soliris io + MY