Publicité
Les langues disponibles
Les langues disponibles
User Manual
To learn more about these features, please refer to the keyboard hotkey switching options below. The
white (or green) port LEDs refer to the KVM section status, the red port LEDs refer to the USB hub
selection status and shows the port/computer currently selected.
Keyboard Hotkeys
Hotkey commands can be activated pressing leading code "Scroll Lock" + "Scroll Lock"* within 2
seconds.
Hotkey
Leading code + "1", "2",
"3" or "4"
Leading code + "Z" (or Y) Bind KVM & Hub switching (Default, Z for QWERTY kb!).
Leading code + "X"
Leading code + "Q"
Leading code + "W"
Leading code + "F1",
"F2", "F3", "F4"
Leading code + "F5",
"F6", "F7", "F8"
Leading code ↓
Leading code ↑
Leading code + ←
Leading code + "B"
Leading code + "S"
Leading code + "S" + (z)
z= 0~9
Leading code + "H" +
"Num Lock", "Caps
Lock", "F12" or "Esc"*
*: To change the universal hotkey from the front push buttons please press the highest port button until
you hear two short beeps. Then press the chosen new hotkey on your keyboard, the KVM switch will
confirm this by a short beep and the hotkey is permanently changed.
Function
Computer port selection 1, 2, 3 or 4.
Unbind KVM & Hub switching.
Bind KVM & Audio switching (Default).
Unbind KVM & Audio switching.
Switch USB Hub to port 1, 2, 3 or 4.
Switch Audio devices to port 1, 2, 3 or 4.
Switch one port down.
Switch one port up.
Switch to the previous port.
Switch on/off beep signal.
Start Autoscan. Press any button to stop Autoscan.
Start Autoscan and set up scan delay withing a range of 10~100 sec.:
1= 10"; 2= 20"; 3= 30"; 4= 40"; 5= 50"; 6= 60"; 7= 70"; 8=80"; 9= 90";
0=100".
Press any button to stop Autoscan.
Change leading code to "Num Lock", "Caps Lock", "F12" or "Esc"*.
English
Publicité
