Niko 65-411 Mode D'emploi page 47

ε
65-411
R,L,C
Memory function:
The dimmer can be used with or without memory. The standard setting of the dimmer is simple push
button mode with memory function. To set the dimmer without memory function, it is sufficient to
press the 'control' key for 10s. at max. light level. After 10s., the light will decrease from maximum
to 50% to indicate that the memory function is switched off. Release the push button immediately
after this change in light intensity. If the push button is not released immediately, there will be
no switchover from 'with memory' to 'without memory' or vice versa. Repeat the procedure to
reactivate the memory function. This function, as well as the last set light level, is saved in a
non-volatile memory. The settings will not be lost in the event of a power failure.
With memory function, the dimmer first switches on at the minimum light level. The dimmer then
switches on at the last set value.
With memory
Press briefly = switching on/off, "on" at previous level
Keep pressing = dimming up/down
Keep pressing when dimmer is "off" = dimmer dims up from 0%
When dimming up: dimmer stops at maximum value
When dimming down: dimmer stops 2s. at minimum value and then dims up.
A renewed (long) press reverses the dim direction
Without memory
Briefly press when dimmer is "off" = dimmer is always switched on at maximum value.
The other operations are identical to those 'with memory'.
In case of a combination of DALI control and simple button control, the last control is given priority
and overwrites the previous dim level.
B. Meaning of LEDs during normal operation
The dimmer has a number of 'mode' LEDs (see fig.1).
These LEDs indicate the current mode of the dimmer (phase control or reverse phase control)
and how it was activated (automatically or manually). To set the mode: see 3.B.Selection of dim
principle - 'mode'.
45 EN