Niko 65-411 Mode D'emploi page 42

ε
65-411
R,L,C
Read the complete manual before attempting installation and activating the system.
1. DESCRIPTION
This universal DALI dimmer is designed for DIN-rail mounting and is 6U wide (108mm). The
universal dimmer will dim resistive, inductive and capacitive loads. The loads may be mixed. The
total connected load is max. 1400VA. The dimmer functions both as a phase control dimmer
and as a reverse phase control dimmer. This choice can be made automatically or manually. The
dimmer can be used with our without memory. It is provided with automatic detection and display
of over voltage, overload and temperature protection.
The dimmer is connected to the DALI bus and consequently can be controlled by the different
DALI commands from a DALI control. Moreover, the dimmer can be controlled by means of a
classical, simple button control with push buttons.
2. INSTALLATION AND CONNECTIONS
The dimmer is 6U wide and can be mounted in a DIN-rail cabinet.
The load (min. 100VA, max. 1400VA) must be connected to the 'load terminals' between terminal
N and terminal ' '(see fig. 1).
The control is connected to the 'control terminals' (see fig. 1). The following 2 operating modes
are possible: via the DALI controls on the DALI bus (to be connected to terminals 2 (('DALI+')
and 3 ('COM')) and simple button control with push buttons (to be connected to terminals 3
('COM') and 4 (' ')).
/ 0-10V /1-10V
See also connection diagrams.
EN 40