Niko 65-411 Mode D'emploi page 44

ε
65-411
R,L,C
If everything has been connected correctly and the power is switched on, all LEDs will light up
simultaneously for 1s.
A connected load can be operated manually by means of the 'select' key. The 'select' key functions
as a simple push button control.
3. PROGRAMMING
Putting the dimmer into programming status: Press the 'programming' key for >2s. The programming
status always starts in section 'physical select'. The accompanying LED blinks. The order the
different sections are run through by repeatedly pressing the 'programming' key' is 'physical
select', 'mode'.
Saving settings and exiting programming status: press the 'programming' key for >2s.
If no action is performed in the programming status for 3min., the programming status will be
automatically exited without the modifications being saved.
A. 'physical select'
'Physical select' makes sure the dimmer is recognized and activated on the DALI bus in combination
with other DALI systems. In combination with the Niko DALI system, this mode has no function
as the selection is made automatically.
To carry out 'physical select', you proceed as follows:
Press the 'programming' key for > 2s. The dimmer now is in programming status, in section
'physical select'. The 'physical select' LED blinks (see following diagram).
To exit the programming status: push the programming key >2s. To switch to 'mode', see § B.
> 2s.
prog
EN 42