Niko 65-411 Mode D'emploi page 46

65-411
In programming status, the 'mode' LEDs can indicate the following:
LED status
100...1400VA
100...1400VA
Upper LED blinks.
100...1400VA
100...1400VA
Lower LED blinks.
100...1400VA
100...1400VA
Both LEDs blink.
To save the settings and exit the programming status: press the 'programming' key >2s.
4. OPERATION
A. Operation in the different modes
Operation via DALI (S265411)
When the dimmer is connected to the DALI bus and is activated, it can be controlled by every
commando of the DALI controls on the bus. For programming and controlling the DALI systems, see
the manuals of the DALI products. After a power cut (> 3s.), the dimmer will be switched off.
Simple button control
Operation input 1 (terminals 3 - 4):
Input 1 has a simple push button control (S165411).
EN
meaning
100...1400W
Selection of: 'manual reverse phase control' (suitable
for capacitive, resistive and mixed loads)
100...1400W
Selection of: 'manual phase control' (suitable for inductive
loads)
100...1400W
Selection of: 'automatic'
ε
R,L,C
44