CRATONI SMART-BIKE Mode D'emploi page 29

i. Now, switch on your Smart Helmet and the remote control, if applicable.
j. Pair your device with the CRATONI Connect App.
k. The installation of your CRATONI Smart Helmet is now completed.
Information! After successful initial set-up, you only have to switch on Bluetooth, the location
services (iOS) or the location (Android) of your smartphone for future use. If you switch on the
helmet and the remote control, if applicable, the helmet will be automatically connected.
5.1. GENERAL OPERATION
5.1.1 CHARGING THE BATTERY
Connect your helmet with a power source using the enclosed charging cable [Fig. 6b/8b]. Your
helmet will be switched off during charging and cannot be used.
• During charging, the LED is illuminated in red.
• Once the device is fully charged, the LED goes out..
Information! Do not forget to switch off your helmet after use.
5.1.2 SWITCH-ON
Quickly press the On/Off button [Fig. 6a/8a] of your helmet. As soon as the helmet is ready for
use, a "Power on" resounds.To switch the helmet off, press the On/Off button once again. A
"Power off" resounds (with helmets with an LED, the latter goes out).
5.1.3 CRASH SENSOR
The CRATONI Smart Helmets have a crash sensor. It is located in the black box inside the helmet.
If an accident is detected, the black box is activated. As soon as an accident is recorded, your
position will be sent to your emergency contacts by SMS; if necessary, they can now inform the
rescue forces.
Important! The crash sensor does not inform emergency centres or the like.
In order for the crash sensor to work. The following points have to be observed:
• The helmet must be coupled with a smartphone and the free CRATONI Connect App. The APP
must always be active during use.
• The location must be activated and calibrated.
20