gdw 1464 Instructions De Montage page 5

Isuzu D-Max 4 x 4
01/2004 - ....
Ref.
Fitting instructions
1) Remove original bumper for good and disassemble bumper fog lamp, remove exhaust from the
dampening rubber. Remove the spare wheel.
2) Place the towing hook with points (A) and (B) on the freed drillings where the bumper was attached. (A)
fits with drillings in the exterior of the chassis beam and (B) fits with drillings on the bottom of the
chassis beam, insert bolts and pinions and tighten everything
3) Atach the fog lamp support (2) with the enclosed bolt on point (D) of the towing hook. Assemble the fog
lamp on (G) of the fog lamp support.
4) Assemble part 1 with points (E) and (F) in the centre of the towing hook on points (E) and (F), insert bolts
and pinions and tighten firmly (see points of attention).
5) Assemble ball (fig.2), insert bolts and tighten firmly.
6) Reassemble exhaust onto the damping rubber and again place the spare wheel in its former position.
Composition
1 tow bar reference 1464
2 nuts M16 – DIN 934
2 security washers M16 – DIN 128A
6 bolts M12x35
– 1/25
8 security washers M12 – DIN 128A
4 bolts M10x35 –
1/25
5 security washers M10 – DIN 128A
4 washers 30x10,5x2,5mm – DIN9021
1 bolt M10x30 – DIN 933
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
1464
(F)
(F)
– DIN 961 (A)
(A-E)
– DIN 961 (B)
(B-D)
(B)
(D)
firmly (see points of attention)
1 nut M10 – DIN 934
2 bolts M12x110 – DIN 961
2 nuts M12 – DIN 934
2 washers 13x24x2,5mm – DIN125A
2 bolts M16x110 – DIN 931
1 fog lamp support (2)
2 caps 70x70mm
All bolts and nuts: quality 8.8
(D)
(E)
(E)
(E)
(F)
(D)