Publicité
Les langues disponibles
Les langues disponibles
04 07 13 / 11.11 / VA
Packing list: 1 12-conductor cable set
1 13-pin socket
1 Socket retaining plate
1 Trailer indicator modules
1.
Disconnect the earth lead from the battery.
2.
Remove cover of boot bottom, wall casing of rear lock and both side boot hatches.
3.
In order to draw cable set, drill additional 40 mm diameter hole. In vehicles without Park Distance Control (PDC),
the hole is located under right rear parking light. In vehicles with PDC, the hole is located in a flat place of rear wall
of spare wheel well. Secure the drilled hole with an appropriate anti-corrosion remedy.
4.
Connect cable set in the following way:
a)
Draw end of 12-conductor set of cables with metal terminals from boot thought the hole referred to in item 3
outside, then pull it through the hole in plug socket holder. Fasten initially assembled cable sleeve in the
aforementioned hole.
b)
There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow
hook with folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other
washer assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow
hook without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c)
Socket is connected according to the following scheme:
Picture1
Contact description
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Assemble connection socket with packing washer using enclosed screws and nuts on socket holder:
a)
Carefully fasten washer in the appropriate way,
b)
Fasten electric bunch in such a way that there are no sharp bends and no wear.
Electrical Set for Trailer Connection
Part no. 04 07 13
13-pin BMW 5 er E 39 manufactured 12.95 -09.00
1 Nuts M6
3 Screws M5X35
3 Nuts M5
1 Screws M6X10
Installation instruction
Cable colour
1
black/white
2
grey
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
2
red/blue 2,5mm
10
2
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
4 Spring washer
1 Fuse base with a fuse
1 Red connection cable
1 Sheet-metal screw
9
10
11
2
Contact description in
13-pin socket
2
10 Cable ties 100 mm
3 Cable ties 300 mm
2 Self-adhesive tape
8
7
1
6
2
4
3
5
12
13
Publicité
