Light Kit Led Driver Replacement - Emerson LURAY ECO CF860B000 Mode D'emploi

14. Light Kit LED Array Assembly Replacement
14.4
Disengage the fan motor assembly 2-pin wire connector
from the 2-pin wire connector of the Light Kit Assembly
14.5
(Figure 40).
Install new Light Kit Assembly by following the
Section 5, Steps 5.2 through 5.4.
Restore electricity and verify function of the Light Kit.

15. Light Kit LED Driver Replacement

The Light Kit Driver is located in the motor
assembly.
The entire ceiling fan will have to be unwired and
removed from the ceiling outlet box.
If you feel that you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician to complete this repair.
15.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to remove
the ceiling fan from the mounting bracket.
Tools Needed
One Phillips head screwdriver
One stepladder
FAN MOTOR ASSEMBLY
2-PIN CONNECTOR
LIGHT KIT ASSEMBLY
2-PIN CONNECTOR
Figure 40
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
27
(Continued)
WARNING
WARNING