Ammann ABS 68 Instructions De Service page 25

1. Safety regulations
Refuelling
Only refuel the machine with the engine switched off.
Do not refuel the machine in enclosed areas.
Avoid naked flames, no smoking.
Avoid fuel spillage.
Collect spilt fuel in a suitable container and prevent spillage
entering the soil.
Do not inhale petrol fumes.
Maintenance
Only qualified and authorised persons may carry out
maintenance work.
Keep unauthorised persons away from the machine.
Never carry out maintenance work with the engine running.
Park the machine on a level, firm surface.
Working on the fuel system
Avoid naked flames, no smoking, avoid fuel spillage. Collect spilt
fuel in a suitable container and prevent spillage entering the soil.
Dispose of spilt fuel in an environmentally acceptable manner.
Do not inhale petrol fumes.
Working on the engine
When working on the air filter, no dirt must fall into the air duct.
Do not work on the exhaust when hot; risk of burns!
When working on the engine exhaust port, no combustion
residues must fall into the cylinder.
Do not touch the piston with cleaning tools.
Working on the tamping plate
Wipe off any excess oil, collect spilt oil in a suitable container and
dispose of in an environmentally acceptable manner.
Keep oily materials in a specially marked container and dispose
of in an environmentally acceptable manner.
Cleaning
Never clean the machine with the engine running.
Never use petroleum spirit or other flammable materials for
cleaning purposes.
When using pressure cleaning equipment, do aim the jet directly
at electrical parts and insulating material or cover these
beforehand.
Do not place the water jet directly in the air filter, exhaust or air
intake port.
After completing maintenance work
Refit all protective devices on completing maintenance work.
Repair
Only qualified and authorised persons may carry out repairs.
Exhaust gases are dangerous! When starting the machine in
enclosed areas, sufficient ventilation must be ensured!
If the machine should break down, hang a warning sign on the
control arm
Testing
Road rollers, trench rollers and vibrating plates and tampers
must be tested for safety depending on the operating conditions
as required, however at least once a year by an expert.
21