Start Up - CombiSteel 7478,0515 Mode D'emploi

You must be sure that the feeding water has been installed and the water vane is turned on.
You must be sure that the wastewater installation was done properly and discharging hose was coupled with discharging pipe tightly.

10. START UP

The figures of control panel on the devices have been shown. According to these figures, as earlier mentioned, the device, whose
electrical connection was made fully and correctly, is operated by turning on control switches.
0-1 switch (main switch) on the device, whose electrical connection was made, is brought into "1-2-3" position. Then, adjusting the
thermostat to the desired temperature, it is expected that the heater surface should be heated.
When the thermostat lamp lights off, it means that the heater has reached desired temperature
While the devices are in operation, do not keep burning material (plastic bags, table napkin, clothe etc.) near them.
Do not operate the device out of the liquid levels which are mentioned on the table
After using the device, bring all control control switches in to "0" position and switch off electric energy.
While device is in operation, the device, heater, top side and front panels reach to high temperature. Do not touch these parts in no
way.
CONTROL PANEL
A –Main Switch B –Signal Lamp
16/36