Introduction; Machine Placement; Operating Instructions; Using Standard Surecut And Clearcrop Dies - Ellison PRESTIGE SpaceSaver Manuel D'instructions

® ®
Ellison Prestige
SpaceSaver will cut multiple sheets of material at a time from a wide variety of
products (see Materials Guide pages 12 and 13). SpaceSaver applies the
pressure to steel-rule dies that cut through the material. The sharp cutting edge
of the dies is surrounded by rubber to help protect fingers and to eject the
material that has been cut. Place the dies (decorative shapes, letters and
numbers sold separately) in the Die Storage Racks (sold separately). See Helps
and Hints for a suggested storage method (page 7).

Machine Placement

Place Prestige SpaceSaver on a smooth, level, non-skid surface at a height that
is comfortable for the user when standing. No part of the machine should be
allowed to hang over the edge of the work surface.
Place the machine on the work surface with the side of the machine facing the
user and the front of the machine to the right (Figure A, page 5).

Operating Instructions

Pressure
Plate
Die
Material
Cutting Pad
Figure A
Using Standard SureCut
Tiny)
1. Raise the handle all the way up.
2. Place material to be cut against the rubber side of the die and place rubber
side down on the Cutting Pad.
3. Slide the Cutting Pad to center the material and die under the Pressure
Plate (Figure A).
4. Lower the handle one time to cut through the material.
5. Keep a firm grip when raising or lowering the handle.
6. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.

Introduction

™
SpaceSaver arrives assembled and ready to use. Prestige
Back
and ClearCrop
™
Dies (Large, Small and
™
4
Front