Troubleshooting Solutions - Ellison PRESTIGE SpaceSaver Manuel D'instructions

Troubleshooting Solutions

1. Dies do not cut all the way through.
Only cut the recommended number of pieces of material and make sure the
I
" " Shim is in the machine. If dies do not cut all the way through with the
recommended number of pieces and the " I " Shim is in the machine, then the
Cutting Pad is worn out. If Cutting Pad is worn on one side only, turn Cutting
Pad over for a fresh cutting surface. If worn on both sides, properly discard and
replace with a new Cutting Pad. Review Replacing the Cutting Pad (page 9).
If problem still exists, add one or more Mylar Shims under the Cutting Pad until
I
proper cutting is achieved. Always leave the " " Shim in the machine. Review
Recognizing Worn Pressure Bearings (page 10).
2. Upper or lower part of die does not cut.
With a Standard Die, make sure it is centered under the Pressure Plate or try
positioning the portion not cutting further under the Pressure Plate. With a DC
die, try cutting an extra time in the middle of the die.
3. Dies cut through only part of letter or design.
If solutions 1 and 2 have been tried and the dies still don't cut completely, try
cutting fewer pieces of material at a time. Very large or intricate shapes (e.g.,
Snowflake or Spider) require more pressure and may not cut through as many
thicknesses.
4. Edges of letters not smooth.
Cutting Pad is rough. Turn Cutting Pad over. If both sides are worn, replace with
a new Cutting Pad. Review Replacing the Cutting Pad (page 9).
5. Paper letters/shapes come out wrinkled or "embossed."
Press the handle down only far enough to cut (about 3/4 of the way down) or
cut fewer sheets. Center die under the Pressure Plate.
6. Die rubber worn, missing or loose.
Use yellow woodworking glue to attach loose rubber to the dies. If the rubber is
worn or missing, call Ellison for re-rubbering instructions.
7. Rubber does not eject all parts of the cut material.
Use the Die Pick to remove excess material after each use. If rubber is worn or
missing, call Ellison for re-rubbering instructions.
11