Ellison PRESTIGE SpaceSaver Manuel D'instructions page 5

Pressure
Plate
Die
Material
Cutting Pad
Figure C
Figure D
Using Double Cut (DC) SureCut
A Double Cut (DC) Die is twice as long as a Tiny, Small or Large Die and

requires two cuts.
1. Raise the handle all the way up.
2. Place the material to be cut against the rubber side of the die and place
rubber side down on the Cutting Pad.
3. Slide the Cutting Pad to position the material and die flush with the back of
the Pressure Plate (Figure B).
4. Lower the handle one time to cut through the material.
5. Raise the handle to slide the Cutting Pad through the machine so the
exposed end of the die is now flush with the front end of the Pressure Plate
and cut again (Figure C).
6. With some DC dies, like Borders and Words, it may be necessary to cut a
third time in the middle of the die. Center die in machine and lower the
handle to cut again (Figure D).
7. Keep a firm grip when raising or lowering the handle.
8. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.
Back
Figure B
™
and ClearCrop
™
5
Front
Dies