Introduction; Machine Placement; Setting Up The Big Shot Pro Machine - Ellison Sizzix Big Shot Pro Livret D'instructions

1. Introduction

®
The Sizzix Big Shot
for full assembly and operation. The Big Shot Pro Machine will cut and emboss a
wide variety of materials with the entire line of Ellison, AllStar and Sizzix dies and
embossing tools. See the Materials Guide (page 14) for specifics. When not in use,
place the dies in Sizzix and Ellison Storage Solutions (sold separately).

2. Machine Placement

Lift the Big Shot Pro Machine by its molded handholds at the ends of the Machine.
Place the machine on a clean, flat, sturdy, non-skid surface at a height and
position that are comfortable for the user. No part of the machine should hang
over the edge of the work surface.

3. Setting Up the Big Shot Pro Machine

Parts included:
Item:
( 1 ) Crank Handle
(2) Lock Washer
(3) Screw
(4) Screw Cap Cover
(5) Sliding Tray
(6) Cutting Pad
(7) Adapter Pad
(8) Premium Crease Pad
(9) Mylar Shims (
( 1 ) Crank Handle (2) Lock Washer
(6) Cutting Pad
14 1/4" x 12 1/4" x 1/8"
(36.20cm x 31.12cm x 0.32cm)
™
Pro Machine package includes all tools and parts necessary
Qty:
1
1
1
1
1
1
1
1
) 2
0.1mm
(3) Screw
(7) Adapter Pad
14 1/4" x 12 1/4" x 3/16"
(36.20cm x 31.12cm x 0.50cm)
Tools required:
3mm Allen Wrench (Included)
Die Pick (Included)
3mm Allen Wrench
(4) Screw Cap Cover
(8) Premium Crease Pad
14 1/4" x 12 1/4" x 1/8"
(36.20cm x 31.12cm x 0.32cm)
4
Die Pick
(5) Sliding Tray
15 5/8" x 12 7/8" x 5/8"
(39.69cm x 32.70cm x 1.59cm)
(9) Mylar Shims
0.1mm x 2