Ellison AllStar SuperStar Mode D'emploi

There are many stars in your classroom, but only
one SuperStar. The all-affordable AllStar
Machine creates perfect curriculum-based shapes
from your choice of AllStar Dies and Sizzix® Dies.
Use Sizzix brand Cutting Pads and Platforms with
Sizzix Dies.
Assembly Instructions
Washer
Crank Shaft
Before attaching handle, remove protective cap on
crank shaft and discard. Then attach handle by
sliding washer over hex screw and inserting
through handle and into crank shaft. Tighten hex
screw with hex wrench provided with handle kit.
Press end plug over hex screw until firmly sealed.
Using AllStar and AllStar Long Dies
Paper
Die
Place an AllStar Die on a SuperStar Cutting Pad
with foam side up. Place paper or desired material
to be cut on top of the die. Place the second
Cutting Pad on top of the paper or material to
create a "sandwich."
*AllStar Long Dies require SuperStar Extended
Cutting Pads, sold separately .
Slide the sandwich into the opening of the
SuperStar. Note the rotation of the handle and
continue to rotate it in the same direction until the
sandwich has passed through the opening of the
rollers. Remove the sandwich from SuperStar.
Your die-cut shape or shapes are ready to use!
by
SuperStar
® ™
Hex Screw
End Plug
Handle
Protective Cap
Cutting Pads
"Sandwich"
IMPORTANT SAFETY INSTRUCTIONS
WARNING
– When using this product, basic
precautions should always be followed, including
the following:
a) Read all the instructions before using the
appliance.
b) To reduce the risk of injury, close supervision
is necessary when this machine is used near
children.
c) Do not contact moving parts.
d) Only use attachments recommended or sold
by the manufacturer.
e) Do not use outdoors.
f) Always place and operate this machine on a
clean, flat surface.
g) PINCH HAZARD. AVOID ROLLERS.
h) DO NOT OVERLOAD THE MACHINE.
i) CUTTING HAZARD. AVOID CONTACT WITH
THE DIE BLADE.
j) ADULT SUPERVISION OF CHILDREN
RECOMMENDED.
SAVE THESE INSTRUCTIONS
Maintenance
After prolonged use, Cutting Pads will wear out,
and you may experience inconsistent cutting.
Routinely turning the Cutting Pad will evenly
distribute wear. Replacement Cutting Pads can be
ordered at ellisoneducation.com.
To ensure optimal performance of the SuperStar
die-cutting system, cut one piece of material at a
time. See exceptions at
ellisoneducation.com/materials_guide.