Installing Indoor Unit - Gree GMV-ND22C/A-T Manuel D'utilisateur

2.4 Installing Indoor Unit

2.4.1 Preparation
（1）Open the front panel, remove the 4 screws and dismount the front grille while pulling it
forward.
（2）Follow the arrows to disengage the clasps on the front case to remove it.
（3）Follow the procedure below when removing the slit portions.
For Moldings:
Remove the pillars. (Remove the slit portions on the bottom frame using nippers.)
For Side Piping:
Remove the pillars.
（1）Remove the 7screws.
（2）Remove the upper casing (2 tabs).
（3）Remove the left and right casings (2 tabs on each side ).
（4）Remove the slit portions on the bottom frame and casings using nippers.
（5）Return by following the steps in reverse order(3>2>1).
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Multi Variable Air Conditioners Floor and Wall Mounted Type Indoor Unit
7